What You Need to Remove PVC Pipe Glue

Whether you are a DIY plumber, or attempting some other sort of project that requires PVC piping, you will likely be faced with the imminent need to remove some pipe glue. This can pose a challenge since pipe glue is not really glue it all; instead, it is a solvent that melts two PVC pipes together, forming a lasting bond. Fortunately, this type of glue removal is usually only necessary when you need to separate two PVC pipes from one another.

Continue reading to learn what you need to remove PVC pipe glue, including some basic instructions on how to get through the process.

Indianapolis Plumbing Services
Indianapolis Plumbing Services 317-784-1870

Supplies Needed to Remove Glue From PVC Piping

To remove PVC pipe glue, you will need a few materials, including a quality heat gun, a PVC pipe cutter (or hacksaw), tongue and groove pliers, sanding paper, and a pair of thick gloves. You can find all of these materials at your local home improvement store or in the home-improvement section of your local department store.

What You Need:

⚒ Heat Gun (or Hacksaw)
⚒ PVC Pipe Cutters
⚒ Tongue-And-Groove Pliers
⚒ Sandpaper
⚒ Utility Gloves

How to Get Started

The easiest and most effective way to remove PVC pipe glue is to simply cut the pipe below the adhered surface. Simply pick a new point of the pipe, and use your PVC cutters to create a new cut. If reducing the length of your PVC pipe is not an option, you can look to your other materials on hand, starting with your heat gun. A heat gun in the construction world is basically like a super high-powered blow dryer. It is typically used to remove hardened materials on surfaces, such as paint, or in this case, solvent. Just be sure to leave enough room to install new coupling if that’s your intended plan.

If you haven’t already tried twisting the two PVC pipes in opposite directions to disconnect them from one another, you can try this now. Or use your heat gun on a low setting to heat the adhered joint of the PVC pipe. The heat will quickly soften the glue. After heating the glue, try twisting the pipes again. If they still don’t disconnect from one another, apply more heat and try again. Your tongue and groove pliers can help you twist the two pipes in opposite directions with higher torque than just your hands, so you might want to incorporate those into the process for better results.

After Pipes are Separated

After you have successfully separated your two PVC pipes, you will still have some solvent residue left over. To remove this residual glue, grab your sandpaper and get to work. A 220 grit sandpaper sheet is a good abrasive level to start with. If there’s a lot of glue left over on the pipe, you might want a coarser grit sandpaper.

Where to Get Trusted Plumber Advice and Service in Indianapolis, Indiana

Call Weilhammer Plumbing at 317-784-1870 for prompt and professional Indianapolis plumbing service and home plumbing inspections at an affordable price. Master plumber, Mark Weilhammer, is happy to answer your questions about plumbing repair, replacement, installation, maintenance, and more. We offer free advice and estimates as well. Whether you need routine water heater service at home, or a major pipe replacement for a commercial building, our licensed Indianapolis plumbers can do it all, and in a time frame that’s convenient for you!

Indianapolis Indiana Master Plumbers 317-784-1870
Indianapolis Indiana Master Plumbers 317-784-1870
This entry was posted in Plumbers, Plumbing Pipes, Plumbing Service and tagged , , , , , . Bookmark the permalink.